How To Install A New Banister

Download Article

A banister provides additional safety on your staircase and visual appeal to a domicile. With the use of some wood and a few tools and supplies, you will be able to install a banister. The following is a guide on how to install a banister.

Steps

1

Purchase a banister at a abode-comeback store or on the Internet.
two
Determine the right height for the banister. ^[ane]
- Contact your local building department for the codes that govern the installation of banisters.
- Marker the wall adjacent to the elevation and bottom stairs with the correct height. Stand a level vertically to ensure the accuracy of your markings.
- Connect the markings with a chalk line.
Advert
iii
Locate the studs in the walls. ^[two]
- Practice this by using a stud finder.^[3]
- Marking the location of each stud on the wall.
4
Cut a piece of wood that fits the bottom of the banister. ^[4]
- This will be the mounting strip.
v
Screw the mounting strip onto the wall. ^[five]
- Align the screws with the studs.
6

Utilise painter'southward tape to the areas of the wall that are near the mounting strip.
7
Stain the mounting strip.
- The color should friction match the banister.
- Be certain to apply 2 coats of stain.
eight

Remove the painter's tape.
9
Cut the banister to fit the staircase.
- Measure the total amount of wood that y'all will demand to fit the staircase.
- Use a power saw to cut the banister.
- Miter the ends of the banister. Utilise a miter box to practise and then and follow the instructions that apply to the brand that you lot choose.
x
Apply the banister to the mounting strip.
- Mark evenly spaced areas on the painter'due south tape that you will use to screw it in. These should not coincide with the holes that y'all drilled for the mounting strip.
- Screw the banister into place.
11
Miter a cap for each end of the banister.
- Employ a miter box to do so and follow the instructions that apply to the brand that you choose.^[half-dozen]
- Be sure that the caps fit the ends of the handrails properly.
- Glue them into place.
- Screw them into identify to ensure that they remain sturdy.
12
Install pre-cutting wooden pegs into the holes on the banister. ^[7]
- These should accept either come with your banister or be available at a hardware or home improvement store.
- Exist sure that they match the colour of the banister.
- Gently employ a hammer to secure the pegs into the banister.
Advertisement